| Execution |
Unshielded |
| Category |
6 |
| Bandwidth, MHz |
250 |
| Cable type |
UTP |
| Connector Type |
2xRJ45 / 8P8C |
| Wiring diagram |
Both ends according to T568B standard |
| Protective cap |
Jellied, with latch protection |
| Conductor type |
Stranded |
| Diameter of conductor insulation, mm |
26 AWG (7×0.160 ± 0.1) |
| Insulation material |
Polyethylene (PE) |
| Outer sheath material |
Polyvinyl Chloride (PVC) |
| The diameter of the outer shell, mm |
5.6 ± 0.3 |
| Colour |
Gray |
| Length, m |
0.5 1 1,5 2 3 5 |
| Compliance |
Complies with standards: ISO / IEC 11801, EN 50173 and TIA / EIA-568 |
| Supported Applications |
10BASE-T, 100BASE-TX, 100BASE-T4, 1000BASE-T, |
| Temperature range, С |
Storage – from -20 to +60.Operation – from -20 to +50 |
| Guarantee |
1 year |
| Packaging |
Individual – plastic bag |
Cat6 Ethernet UTP 3m
Next product
Cat6 Ethernet UTP 1m
KSh100.00
KSh250.00
In Stock
Highlights:
This patch cords are widely used in any cabling system and are designed to connect communication lines with active network equipment through patch panels, as well as to connect computers in workplaces to patch outlets. They provide high reliability of the connection and allow, if necessary, to quickly re-connect. Patch cords consist of a segment of a multicore patch cable terminated with RJ45 / 8P8C connectors, correspond to category 6 (250 MHz) and are intended for use in communication lines with a data transfer rate of up to 10 Gb/s. The cable routing in the patch cords is made according to the T568B standard. The connector mounting location in the NETLAN cords is protected by a filler cap, which significantly increases the life of the patch cord.
Description
Related products
PoE Splitter
Highlights:
here are two situations when PoE splitter is used in a network: One is the network in which PoE switch and non-PoE devices to get powered requires a connection; another is the network in which data is sent through non-PoE network switch or router connecting with PoE compliant or non-PoE compliant end devices.
As shown in the following figure, the power sourcing equipment—the PoE switch provides power source via the Ethernet Cable. In this situation, the input cable of PoE splitter can connect with the switch directly. One output line supplies data and the other power. When a splitter receives a unified PoE signal, it then separates the data and power into the two different lines to the non-PoE end devices such as IP cameras and wireless access points.
Reviews
There are no reviews yet.